|
Generally, there seems to be two basic types of bandages on the non-competing race horse: stable bandages and
standing bandages. While some horsemen used these terms interchangeably as one, I have always considered them distinct bandage styles. Stable bandages cover the leg from just below the ankle to just below
the knee. The standing bandage extends a bit longer to around the coronary band of the hoof up to the lower knee. Standing bandages are used more as shipping bandages, since it offers added lower protection while
the horse is in transit. Standing bandages may have an extra sheet or two of cotton, too. Bandages are as individually designed and applied as there are different
personalities of horsemen. Every trainer who has wrapped horses for any length of time has preferences and styles. You must find your own. If old fashion sheet cotton is used, usually three sheets are
incorporated into one stable bandage. These three sheets may be molded into one pad in any number of ways and configurations. One of the more complex methods, I have encountered, involved splitting the
outer cotton sheet in half. exposing the fuzzy inner cotton, then using this outer sheet to encapsulate the remaining two sheets. Looked pretty, but not sure it is worth all of the trouble. In the
final analysis, your cotton sheets or pre-manufactured cotton pads should offer smooth consistent support next to the leg. The outer bandages may be of varying types, too. The most common types seen today
are the off the counter
stretchy knit bandages, four inches wide and 3 yards long made my such companies as Walsh and Tracer. The longer, standing bandages are often made from sheet flannel which were cut into approximately six inch wide, four yard lengths. One would buy a bolt of flannel and cut one's own in the past. Now, I see that flannels can be bought ready prepared with velcro closures. Back in the old days strings and bandage pins were used to fasten the finished bandage. Thank goodness strings are no longer around, they were a dangerous method. Cording (tendon damage) of the leg was often possible with strings. Velcro tab closures are pretty much the norm now, though I still like bandage pins, particularly on wide flannel warps.
Bandages are pretty much put on one uniform way on the race track. One usually wraps clockwise around the leg. First place the cotton under-pad (sheet cotton or factory pads)
next to the leg and wrap firmly around the leg. The beginning edge should start on the inside of the horse's leg, and the cotton wrapped firmly, clockwise around the leg. Once the sheet cotton or pad is in
place, one takes the bandage, starting just above the ankle, wrapping over itself, once, to tie the end in place and head downwards to below the ankle, covering approximately a third of the preceding bandage as
one wraps. After reaching the mid-pastern area–leaving a bit of the cotton edge exposed, one heads back upward to end at or slightly below the upper cannon. There is no room for error with the three yards.
Three yards will generally be all that is required to wrap a stable bandage using this route. With the velcro tabs, it is not necessary to end with the bandage on the outside as required if one were using pins.
Pins are always fastened to the outside of a bandaged leg. The bandage should have a smooth, Painted-On look–a sign of an experienced groom. The tricky part is trying to describe the proper
tension which should be applied in wrapping bandages. Bandages should not be wrapped on too tight, but not loose enough to slip over night, either. There are a couple of fail-safe features of bandages that helps
avoid them being put on too tight. One, the knit stable bandages have much stretch to them and, two, the thick cotton pads of the standing bandage tend to provide the stretch that the flannel bandages do not
have. Generally speaking, new cottons will always slip some until they become set to the leg. Stable bandages are used in conjunction with a poultice or sweat
therapies, provided the part being treated resides in the confines of that part of the leg. With a poultice, the bandage is placed over either a plastic sheet or brown damp paper which covers the mud. With a
sweat, wax paper or plastic sheeting separates the bandage under-pad from the leg itself. Bandages for the race are a little different matter. Harness horses are
not bothered with run downs, so their bandaging requirements differs a bit from the Thoroughbreds. With the universal exception of tendon/ligament support in both breeds, race bandages are used on Standardbreds
more for protection from gait interference compared to the Thoroughbred's need for rundown protection. Interference of gait can occur in the Thoroughbred, but usually not too such an extent or seriousness as the
harness horse. Accordingly, racing bandages (brace bandages, as they are called) in harness horse racing are somewhat thicker, heavier with black rubber pads being used underneath Ace
type, elastic bandages. In contrast, Thoroughbred race bandages consists of one sheet of cotton covered by a crepe type of elastic self-sticking bandage, like Vetrap. Plastic taping of the end,
finishes the race bandages, helping to guard against accidental bandage unrolling during a race. Depending on how badly a runner tends to rundown, leather or plastic rundown patches may be wrapped into the ankle
area where such injuries may occur. |